Easy Car Care Tips. Basic Car Care Manual Part 2.




Last updated Basic Car Care Manual Part1. Away this would be a Basic Car Care Manual Part 2. See how what they are.
Items should be checked
     
BasicCar Care Brake fluid level Should be checked by sight Observe that the brake fluid bottle with the word MAX and MIN brake fluid level should be at the MAX level is always possible. That affect the amount of brake fluid in the brake fluid bottle is dropped down to 2 

questions.
- A leak of brakefluid from the brake system.
- Wear of brake The brake fluid level will drop slightly slow in this case, no need to add brakefluid if the fluid level in the brake fluid bottle drops down quickly. Should bring the car to a service center to check the cause.
     
BasicCar Care Clutch fluid level Should be checked by sight Observe the gearbox oil clutch will contain the word MAX and MIN clutch fluid level. Should always, if found at MAX level. Oil-clutch gearbox drops down. Should bring the car to a service center to check for the cause.

     
BasicCar Care Automatic transmission oil level Should be checked when the engine is on. By pulling the shaft AUTO gear check gear oil. Attached with a Dipstick Then plug the stick Oil back to the original point Pull the stick out again. To check oil level at the end of the shaft. If the oil level I show that in the limit F transmission oil level normal.
     
BasicCar Care Check level oil POWER. Should be checked when the engine is on. By rotating the gearbox oil cap is stuck with POWER POWER jars of oil measuring stick the word HOT and COLD on each side of the temple when the engine is still cold , see if measured at the COLD air . Heat to see if a new version of the HOT OIL POWER will see is plastic. The gearbox to the HOT and COLD on each side and struck with MIN MAX level with oil level should be level with MAX POWER always if the engine is cold , see the COLD and see if overheating is the HOT.
     
BasicCar Care Check the belt. By the way, look at the belt if found cracks occur. Should be changed early In order to use it safely. Also, it should check for tension. With belt Using fingers, press down on the belt in the middle. Between the two pulley If you press down slightly to about 10 mm would be adequate. (If unsure, should be examined. Because such a way. Inspectors must have practiced enough).

    
BasicCar Care Internal engine inspection By the way, look around inside the engine compartment. Notice that There is nothing wrong or do not as the radiator hose has water stains or wires inside the engine compartment is good or not. Rats was limited or no oil leak or stain wood.