Easy Car Care Tips. battery no power.
Emergency caused problems with your car
that can’t start the car. Often encountered
frequently is battery no power. May occur for several reasons such
as.
-
Turn the lights off for a long
time.
- Take a short drive or a long car charger until the light is not enough.
- Battery defective or damaged.
- The starter too much battery power is off.
- Take a short drive or a long car charger until the light is not enough.
- Battery defective or damaged.
- The starter too much battery power is off.
How to start car by battery jumper
however work.
1. Opened
up the hood and check the condition of the exterior of a car battery that
nothing unusual.
2. Switch
off all electrical equipment. Such as
air conditioning, Audio system, Lightingsystem and moving the lever to the neutral position, or (N) or (P), then use
the hand brake.
3. Jumper cables battery side (red cables) to the positive terminal of the battery to the
trailer and the other end of the cable clamp (red cables) to the positive
terminal of the battery in car with no fire.
4. Jumper cables battery side.
(Black cables) to the negative terminal of the battery to the trailer and
the other end of the cable clamp (black cables)
to the cathode. The
battery in car with no fire.
5.
Starting
the engine of the car's acceleration and hold it to the trailer.
6. Starting
your vehicle. If
the motor is running slow, make sure that the connection cables in a tight
metal -to-metal contact or not.
7.
When
the engine . Disconnect
the negative cable from the tow vehicle with no power and then disconnect the
negative terminal from the vehicle to tow the trailer and disconnect the
positive terminal of the car has no power and then removed from the vehicle to
the trailer.
Remarks: battery anode has a plastic cover or encase
red rubber. And the size of the battery anode is
larger than the negative.
Remarks: Battery cables should be as large wires. If cables can not start a small battery.
Remarks: Battery cables should be as large wires. If cables can not start a small battery.
CAUTION: Disconnect the battery cables or the
clamp should not touch
the anode and cathode, because it will cause the
battery to short-circuit may
cause harm.
